NEC 1080Xd - Manual (Page 68)

3-18 Service Processor
DF (Shut Down System Power )
Execution:
This command can be executed on a partition which is in one of the following states:
! Automatic startup has completed or the UP command has been executed. (The
partition is in the DC POWER ON state)
! The ON command has been executed. (The partition is in the DC POWER ON
state.)
Function:
This command turns off system power (DC).
This command turns off the system regardless of the operation state of the OS or BIOS
and without notifying either. (This corresponds to the power button override function of
a system that has a physical power button.)
Note: The DF command can be executed in Normal mode or
Maintenance mode.
Table 3-21. DF Screen
Screen Image Reference
iSPyz:---> df
CAUTION:
System power will be turned off without any notice to the softwares even if they are
running.
Enter partition number (0-3/all/CR=exit) : all A
Execute OK? (y/[n]) y B
DF command was accepted. System power of all partitions will be turned off soon. C
[iSPyz:INFO.ccc] partition 0 : power off sequence started.
[iSPyz:INFO.ccc] partition 1 : power off sequence started.
:
:
:
[iSPyz:INFO.ccc] partition 1 : power off sequence completed normally.
D
Table 3-22. DF Screen References
Reference Description
A Enter a partition number. If you select “all”, all the configured partitions become the
targets.
B Displays the confirmation message. To continue, enter “y”.
C Displays the DF command acceptance message.
D Displays the state of the process running in the background.