NEC 1080Xd - Manual (Page 45)

System Operation 2-17
4. Start the OS loader by entering the directory file name, in this example,
setupldr.efi , at the fs0:\os prompt and press Enter .
fs0:\> cd os
fs0:\os> ls
Directory of fs0:\os
03/13/00 05:44p
03/13/00 05:44p
12/22/99 00:58p r 635,392 setupldr.efi
1 File 635,392 bytes
2 Dirs 2,560 bytes
fs0:\os> setupldr
Figure 2-15. Starting the OS Loader from Shell
Notes for OS Installation
See the following notes requiring attention when installing the OS:
! Adding a SCSI card to a free slot and connecting a disk to the SCSI card
after the OS installation, might change the numbering of the disk and
prevent an OS boot from that disk.
! PCI12 slot is set to not run Option ROM BIOS as default. Running
Option ROM BIOS on PCI12 slot requires changing the settings of the
slot with BIOS setup before booting the OS.
EFI Device Path
Each device installed in the system is managed with an “EFI Device Path.” The
following information describes EFI device paths.
See the following examples and Table 2-2 for device path formats for devices
conforming to EDD3.0 specification:
Example: SCSI cards and disks installed on the PCI bus:
Acpi(PNP0A03, 1)/Pci(2|0)/Scsi(Pun0,Lun0)/HD(Part1,SigFF050000)
Example: DVD-ROM device connected to the IDE Secondary channel:
Acpi(PNP0A03,0)/Pci(2|1)/Ata(Secondary,Master)/CDROM(Entry1)
Start OS Loader.