NEC 1080Xd - Manual (Page 185)

I/O Board Installation 5-13
1. Check that the front stabilizer is in the pulled-out position. If not, remove the
screw securing the stabilizer and pull it out (see Figure 5-10).
2. Remove the front bezel from the front of the PCIX unit by pulling it first
from the bottom and then away from the top of the unit (see Figure 5-10).
A Stabilizer
B PCIX Unit Front Bezel
Figure 5-10. Stabilizer and PCIX Unit Front Bezel
3. Remove the two screws (one on each side) securing the PCIX unit to the
front of the cabinet (see Figure 5-11).
A Server Screws (2)
Figure 5-11. PCIX Unit Screws
A
B
A