NEC 1080Xd - Manual (Page 187)

I/O Board Installation 5-15
6. Install the board in the appropriate slot.
Note: See the previous sections in this chapter to
select the correct slot for your board type. Correct slot
location can optimize board performance.
! Carefully remove the slot cover.
!
WARNING
Take care when removing the slot cover. System power is
on during this installation. Dropping a slot cover can create a
short circuit, causing personal injury and damage to the
system if the slot cover makes contact with a connector.
! Insert the board into the slot.
Figure 5-13 PCIX Unit PCI Slots
7. Replace the access cover (see Figure 5-12).
! Swing the cover back over the slots.
! Press the cover down and check that the cover latches are secured.
!
CAUTION
To prevent damage to the cover and chassis, check that the
cover is secured and can clear the chassis when you slide
the unit into the server.