NEC 1080Xd - Manual (Page 35)

System Operation 2-7
10. Enter up on the SP console to bring up the specified partitions
(see Figure 2-7).
The service processor turns on power to the specified partitions, initializes
the hardware, and hands off the control to the BIOS. The BIOS boots the
operating system.
iSPyz:---> up
This command will bring up the specified partition.
Enter partition number (0-7/all/CR=exit) : all
Execute OK? (y/[n]) y
UP command was accepted. All partitions will run soon.
[iSPyz:INFO.ccc] partition 0 : power on sequence started.
[iSPyz:INFO.ccc] partition 1 : power on sequence started.
:
[iSPyz:INFO.ccc] partition 1 : power on sequence completed normally.
:
[iSPys:INFO.ccc] partition 1 : handed off the control to BIOS.
Figure 2-7. System Startup Screen