Paradyne 3166 CSU - Manual (Page 53)

SDCP Operation
3-27 3166-A2-GB20-10 November 1998
7. Press F2 (Enab) to enable trap messages over the SNMP management link.
F1
SNMP Trap:
Next
Enab Disab
F2 F3
Selecting the Number of Trap Managers
If you intend to issue traps to an SNMP manager(s) from this device, you must
specify the number of SNMP managers that are to receive the traps.
"
Procedure
To specify the number of SNMP managers to receive traps from this device:
1. From the top-level menu screen, select Cnfig.
2. Select the configuration option set to be copied into the Edit area by using the
appropriate Function key. Use the scroll keys, if necessary.
3. Select Edit.
4. From the Edit screen, press the key until the Mgmt selection appears on
the screen.
5. Select Mgmt.
F1
Edit:
User
Alarm Mgmt
F2 F3
6. From the Mgmt Config screen, select Trap.
F1
Mgmt Config:
Gen
Trap
F2 F3
7. Select the number of SNMP managers to receive traps (from 1 through 6) by
using the appropriate Function key. Use the scroll keys, if necessary.
F1
Num Trap Mgrs:1
Next
1 2
F2 F3