Paradyne 3166 CSU - Manual (Page 22)

Installation
2-2 3166-A2-GB20-10 November 1998
Installation
"
Procedure
To install the DSU and rear connector module:
1. At the rear of the carrier, set the tab on the rear connector module into one of
the slotted grooves on the carrier’s backplane. Loosely fasten the screws.
Make sure the rear connector module uses the same slot position intended
for the DSU.
NOTE:
If an auxiliary backplane for Models 3151 or 3161 DSUs is installed in the
same carrier, verify that it is mounted over slots 9–16. Slot 9 is rendered
inaccessible if the auxiliary backplane is mounted over slots 1–8.
98-16083
3000 Series
Carrier
Slots
Tabs
Rear
Connector
Module
2. Loosely fasten the screw attached to the rear connector plate, allowing for
slight adjustment that may be needed when installing the DSU.