Paradyne 3166 CSU User Manual
Page 116
Configuration Options
C-14
3166-A2-GB20-10
November 1998
Table C-4.
User Interface Configuration Options (5 of 6)
Ignore DTR: No
Next Yes No Prev
Communication Port Ignore DTR State. Specifies whether the DSU/CSU ignores the
state of the Data Terminal Ready (DTR) input to the communication port.
Yes – DTR is ignored.
No – DTR is not ignored.
CmInActTm: Disab
Next Enab Disab Prev
Communication Port Inactivity Timeout. Specifies whether the communication port
disconnects after a period of inactivity specified by the CmDiscTm configuration option.
Enab – The communication port disconnects after the period of inactivity specified by
the CmDiscTm configuration option.
Disab – The communication port does not disconnect due to inactivity.
CmDiscTm: 5
Next Up Down Save Prev
Communication Port Disconnect Time. Specifies the period of time (1 to 60 minutes)
before the communication port disconnects due to inactivity. (The CmInActTm
configuration option must be set to Enab.) Use the left or right arrow key to position the
cursor on the digit you want to change. Use the Function keys (Up or Down) to
increment or decrement the digit.
Up – Increments the time delay.
Down – Decrements the time delay.
Save – Stores the time delay for use with inactivity disconnects.
TnSession: Disab
Next Enab Disab Prev
Telnet Session Enable. Specifies whether the DSU/CSU responds to Telnet session
requests.
Enab – The DSU/CSU responds to Telnet session requests.
Disab – The DSU/CSU does not respond to Telnet session requests.
TnPaswd: Disab
Next Enab Disab Prev
Telnet Password Mode. Specifies whether a password is required for Telnet access.
Enab – A password is required for Telnet access.
Disab – A password is not required for Telnet access.
TnInActTm: Disab
Next Enab Disab Prev
Telnet Inactivity Timeout. Specifies whether the Telnet session disconnects after a
period of inactivity specified by the TnDiscTm configuration option.
Enab – The Telnet session disconnects after the period of inactivity specified by the
TnDiscTm configuration option.
Disab – The Telnet session does not disconnect due to inactivity.