Polycom SpectraLink 8030 - Manual (Page 99)

Diagnostic Tools
PN: 1725-36038-001_E.doc 99
Where:
• i – index of selected AP (value will be from 0 to 3 inclusive)
• bbbbbb – the last three octets of the BSSID for a discovered AP
• sn – signal strength in –dBm
• ch – channel
• bcn – beacon interval
• eeeeeeeeeee – SSID (up to first 11 characters)
• DGHI – standards supported
• rrrrrrrr – rates supported. Basic rates will have a “b” following the
rate
• + – more rates are supported than those displayed
• xxxx – WMM or UPSD if those QoS methods are supported
• Q:XP
o
X is a hexadecimal representation of the access categories
configured with admission control mandatory (ACM).
Bit3 = voice, Bit2 = video, Bit1 = background, Bit0 = best
effort. For example, if an AP advertises voice and video as
ACM then X=c. If all the ACs are set as ACM then X=f. If
AP does not have WMM support, this character space will
be blank.
o
P is displayed when the AP advertises WMM-PS. If the AP
does not advertise WMM-PS then this character space will
be blank.
• C:vC
o
v is a decimal number indicating the CCX version
advertised by the AP.
o
C is displayed when AP advertises CCKM. If the AP does
not advertise CCKM then this character space will be
blank.
• ssssssss – Security modes: “None”, “WEP”, “WPA-PSK”, “WPA2-
PSK”, “WPA2-Ent”
• Any/MyID – softkey to toggle between “single SSID” and “any
SSID” modes
• Detl/Smry – softkey to toggle between the multiple AP display
(summary), and the single AP display (detail)