Polycom SpectraLink 8030 - Manual (Page 61)

Programming the SIP Handset Features
PN: 1725-36038-001_E.doc 61
Proxy server commands
Use the following parameters when programming the configuration
files. See the sample configuration files following this table for more
detailed information.
Parameter Value Description Notes
PROXYn_ADDR xxx.xxx.xxx.xxx:pppp
or Proxy address. One proxy
address is required but
additional proxy
addresses may be used to
register secondary line
appearances. n = 1, 2, 3
xxx.xxx.xxx.xxx = IP4
address
pppp = port (optional, 5060
is the default)
proxyname:pppp proxyname = computer
name (DHCP only)
PROXYn _DOMAIN Domain name Domain served by this
proxy server. n = 1, 2, 3
DOMAIN = [example:
spectralink.com]
Can be omitted if a specific
proxy domain name is not
defined at the proxy server.
If omitted, defaults to the IP
address of the proxy server
(see above).
PROXYn_TYPE Asterisk 2
NEC (NECSIP)
Mitel
Cisco Call Manager
Express or Unified
Communications
Manager Express.
(CCME)
PingTel
Interactive Intelligence
(ININ)
Toshiba
Cisco Call Manager or
Unified Communcations
Manager (CCM)
3Com
Specify the manufacturer
of each defined proxy
server. See sample files
for vendor notation. Used by the handset to
perform proxy-specific
actions based on known
behavior for specific proxy
types. Only the three
shown values may be
used. Omit this parameter
if the value is not one of
these recognized settings.
2 For up-to-date Asterisk voicemail commands, go to:
http://www.voip-info.org/wiki/index.php?page=Asterisk+cmd+VoiceMailMain