Polycom SpectraLink 8030 - Manual (Page 42)

SpectraLink 8020/8030 Wireless Telephone: Administration Guide for SIP
42 PN: 1725-36038-001_E.doc
Admin Menu Default Table
When the Restore Defaults option is selected, administrative parameters
will be reset to their factory defaults as shown in the table below. The
Telephony Protocol setting will not change. User parameters will be
reset per the user-defined preferences default settings table in the next
section.
Menu option Setting Sub-option Sub-sub-option Default
Phone Config
Push-to-Talk Disabled
Allowed Channels [all]
Name Channels [None set]
Priority Channel Disabled
Time Zone GMT
Daylight Saving DST No Adjust
Password Enabled
Change Password [n/a]
SIP Registration [None set]
Clear Regist. [n/a]
OAI Enabled
Location Service
RTLS Disabled
Transmit Interval 10 minutes
Location Server IP [None set]
ELP Port 8552
Network Config IP Addresses Use DHCP
SSID* [None set]
WLAN Settings Custom/Security None
WEP Key Length 40 bit
Custom/QoS QoS (Mode) SVP
QoS (DSCP
tabs) WT in call = 46
WT standby = 26
Other = 0
Cisco FSR Username [none set]