Polycom SpectraLink 8030 - Manual (Page 40)

SpectraLink 8020/8030 Wireless Telephone: Administration Guide for SIP
40 PN: 1725-36038-001_E.doc
All softkey to apply that level to all subbands and return to the
subband menu where all subbands will now be selected. All
overrides any previously set power transmit levels.
Without subbands: When the 802.11 mode has no subbands, the
Transmit Power list opens when NavOK is pressed to set the
mode. Only those power levels which apply to the domain
and 802.11 mode are listed. Navigate to the desired level and
press
NavOK . This sets the transmit power level and exits the
Regulatory Domain menus. The Network Setup menu will again
display.
Note that the power setting selected here specifies the
maximum for that band/subband. When Transmit Power
Control (TPC) is enabled in the infrastructure, the AP may
instruct the handset to use a lower value to match its own
transmit power.
Diagnostics
Run Site Survey
The Site Survey mode is activated by selecting this option. The site
survey starts running immediately upon selecting this option. See the
Diagnostic Tools section for more information about site survey.
Diagnostics Mode
Diagnostics can be enabled or disabled. See Chapter 8 Diagnostic Tools,
section Diagnostics Enabled for a detailed explanation of the
Diagnostics
mode options.
Syslog Mode
See Chapter 8 Diagnostic Tools, section Syslog Mode for a detailed
explanation of the
Syslog mode options.
Error Handling Mode
The Error Handling mode determines how the handset will behave
when an error occurs. The Halt on Error option will cause the handset
to stop operating if an error message is received. Unless the error is a
fatal one, normal operation may be resumed by power-cycling the