Screen 6 – eap information – Polycom SpectraLink 8030 User Manual
Page 104
SpectraLink 8020/8030 Wireless Telephone: Administration Guide for SIP
104
PN: 1725-36038-001_E.doc
S e c - E r r C o u n t n n n n n
L s t S e c E r r S e q n n n n n
Q o S F a i l C n t n n n n n
Screen 6 – EAP Information
• “xxxxx” in Line 1 is a 5-digit decimal value displaying the EAP
authentication failure/error count.
• “xxxxx” in Line 2 is a 5-digit decimal value displaying the error
code/sequence for the last EAP authentication reason, listed just
below. Line 2 will be blank if the count for Line 1 is zero.
• 1 = Unknown error
• 2 = Mismatch in EAP type. The phone is configured with an EAP
type (Cisco FSR, PEAP or EAP-FAST) that is not supported by the
AP.
• 3xxx = Certification failure. The certificate presented by the server
is found as invalid. “xxx” when having a non-zero value, is the
standard TLS alert message code. For example, if a bad/invalid
certificate (on the basis of its signature and/or content) is
presented by the server “xxx” will be 042. If the exact reason for
the certificate being invalid is not known, then the generic
certificate error code would be xxx=000. [Refer
.2 for further TLS
alert/error codes].
• 4xxx = Other TLS failures. This is due to TLS failure other than
certification related errors. The reason code (the TLS alert
message code) is represented by “xxx”. For example, if the
protocol version presented by the server is not supported by the
phone then xxx will be 70, and the EAP error code would be 4070.
tion 7.2 for further
TLS alert/error codes].
• 5xxx = Security credential Failure. This is due to an invalid
username and/or password produced by the phone. xxx when
non-zero, presented the 3-digit error code sent by the server in
response to phone’s credential. For example, if the server has sent
the error code as “691”, then the EAP error code would be 5691. If