Polycom SpectraLink 8030 User Manual
Page 31
SpectraLink Wireless Telephone Configuration
PN: 1725-36038-001_E.doc
31
SIP Registration
Individual handsets may be configured to correspond with the SIP
configuration information in the TFTP server. The handset is then
automatically identified at startup. If username and password
information is not configured in the
Admin
menu, then this
information will be requested at startup
In either case, the username must agree with a corresponding
configuration file. See Chapter 5 Programming the SIP Handset Features,
section SIP TFTP Server Configuration Files.
Login
allows you to specify a username and password for
automatically acquiring SIP configuration information. If no
username is specified, the SIP handset will request username and
password at startup and any additional registrations specified here
are ignored.
The username should correspond to the primary (line 1) dial number
assigned to the user. The username and password should also
correspond to the authentication credentials as created by your
system administrator for your primary line registration. Usernames or
passwords can be erased by selecting the item, then pressing the
Bksp
softkey and then the
Save
softkey.
Reg 2
,
Reg 3
, and
Reg 4
allow you to specify additional authentication
usernames and passwords that may be required by your handset for
any additional line appearances (registrations) that may appear in the
specific user’s configuration file. This information will be ignored if a
Login
username is not provided.
OAI Enable/Disable
Polycom’s Open Application Interface (OAI) enables third-party
computer applications to display alphanumeric messages on the
handset display and take input from the handset keypad. Refer to the
OAI Specification (Version 2.0) documentation for information about
administering the OAI Gateway and the services it can provide.
If you have an OAI Gateway installed in your system, OAI may be
optionally enabled in each handset. You may select whether the
handset should attempt to connect to the SpectraLink 8000 OAI
Gateway by choosing either the
Enable
or
Disable
options in this menu.
If OAI is enabled, and an IP address (called the
OAI Server IP
) is
available to the handset (either via DHCP or Static IP configuration),
the handset will communicate with the OAI Gateway at power-on,
and periodically while it is powered-on. If you don’t have a