Printronix H-SERIES P7000 - Manual (Page 95)

Hangul LP+ Emulation
95
CPI/LPI Select
This parameter lets you specify the characters per inch (cpi) and lines per
inch (lpi) values. The defaults are 10 cpi, 6 lpi, and 6.7 cpi for the Hanzi LP+
printer. For the Hangul LP+ printer, the default is 6 cpi and 6 lpi. For the Kanji
LP+ printer, the default is 15 cpi, 8 lpi, and 7.5 cpi.
Host Command
• Enable. Enables all host printing commands.
• Ignore All. This function treats all control codes and printing commands
as the data.
• Ignore CPI. This function ignores the CPI selection commands only (e.g.,
ESC M, ESC P, and ESC G).
• Ignore LPI. This function ignores the LPI selection commands only (e.g,
ESC 2 and ESC 0).
• Ignore Unidirectional (the default). All unidirectional commands sent by
the host are ignored by the printer.
• Ignore Pg. Fmt. All page format commands sent by the host are ignored
by the printer. This is applicable only for Hangul LP+ printers only.
Font Attributes
This submenu allows you to define the following font attributes: typeface,
proportional spacing, bold print, and italic print. You can also specify if the
zero character will print with a slash.
For the Hanzi GB and Kanji LP+ printer, the default typeface is Near LQ. For
the Hangul and Hanzi Big5 LP+ printer, the default is LQ.
High Density enabled will allow the LQ typeface to print in higher print density.
It will not take effect when other typefaces are selected.
Text position specifies where the text will be positioned in the line space.
When set to Top of Line, text will be positioned at the top of the line space.
When set to Bottom of Line, the text will be positioned as if it were at the
bottom of a 6 lpi line space. The following example shows both Top of Line
and Bottom of Line text positions:
Top of Linespace
Bottom of 8 LPI Linespace
Bottom of 6 LPI Linespace
Dot
Row
Text Position
Top of Line
Text Position
Bottom of Line
1
1
2
3
4
5
6
7
8
9
10
11
12