Printronix H-SERIES P7000 - Manual (Page 149)

Fault Messages
149
E32D CND 3 BP
See User Manual Yes An illegal or unsupported
instruction was attempted in
the application program. 1. Cycle Power. Run the
print job again. If the
message appears, load
the latest emulation
software.
2. Cycle power. Run the
print job again. If the
message appears,
record the display
message and send it to
your next higher support
facility.
E32E CND 4 BP
See User Manual Yes An illegal or unsupported
instruction was attempted in
the application program. 1. Cycle Power. Run the
print job again. If the
message appears, load
the latest emulation
software.
2. Cycle power. Run the
print job again. If the
message appears,
record the display
message and send it to
your next higher support
facility.
E32F CND 5 BP
See User Manual Yes An illegal or unsupported
instruction was attempted in
the application program. 1. Cycle Power. Run the
print job again. If the
message appears, load
the latest emulation
software.
2. Cycle power. Run the
print job again. If the
message appears,
record the display
message and send it to
your next higher support
facility.
Table 12. LCD Message Troubleshooting Table
Displayed Message
Can User
Correct?
Explanation Solution