Printronix H-SERIES P7000 User Manual

Page 29

Reload Paper

24. Pedestal models:

Using the vertical position knob to move the paper up, guide the paper
over the lower paper guide and through the slot in the top cover. For
pedestal models with the Quick Access Cover, refer to the

Quick Setup

Guide for paper exiting options.

25. Press PAPER ADVANCE several times to make sure the paper feeds

properly beyond the tractors and over the lower paper guide. Feed
sufficient paper to ensure the paper stacks correctly.

26. Cabinet models:

Open the cabinet rear door. Make sure the paper is aligned with the label
in the output area (inside the cabinet). Close the front and rear doors.

Figure 14. Aligning the Perforation with the TOF Indicator

27. Align the top of the first print line with the TOF indicator on the tractor by

rotating the vertical position knob. For best print quality, set the top-of-
form at least 1/2 inch below the perforation.

NOTE: For exact positioning, press the VIEW/EJECT key to move the last

data printed to the tractor area for viewing. While in View mode
“Printer in View” displays. Press the Up or Down Arrow keys to move
the paper vertically in small increments. Pressing the VIEW/EJECT
key a second time moves the paper back to the adjusted print
position. The key owrks both online and offline provided that the
printer is in View mode. (This procedure is applicable for both the
cabinet and pedestal models.)

Perforation

TOF Indicator

Vertical Position Knob