Printronix H-SERIES P7000 - Manual (Page 56)

56
Chapter 4 ZTP SETTINGS
Save Config.
This option allows you to save up to eight configurations to meet different print
job requirements. This eliminates the need to change the parameter settings
for each new job. The configurations are stored in memory and will not be lost
if you turn off the printer. If the Protect Configs. parameter is enabled, the new
configuration will not be saved unless the existing configuration has been
deleted first. The factory default configuration cannot be changed. See
“Saving Your New Configuration” on page 44 for details.
Power-Up Config.
You can specify which of the nine configurations (Factory or 1-8) will be the
power-up configuration.
ZTP SETTINGS
ZTP Function
This option enables or disables all unique ZTP functions. The default is
Enable.
NOTE: When the ZTP Function is enabled, the View/Eject key is disabled
and Slow Paper Slew is enabled.
ZTP TearDistance
This option sets the tear off distance from the current print position to the tear
bar. Adjustable values in increments of 1/144th of an inch range from 200 to
2880. The up and down arrows adjust the display value. When you press the
Enter key, the selected value is stored and a scale is printed to indicate the
current tear off position. The default value is 1060.
NOTE: When a new value is selected, the printer will lose the current print
position. You must reset the top of form to automatically save the new
value.
ZTP
SETTINGS 1
(from page 50)
ZTP
Function
ZTP
TearDistance
ZTP
Data Time
ZTP
Wait Time
ZTP
Platen Open
Enable*
Disable 1074/144 Inch* .5 Sec*
1.0 - 5.0 Sec
2 Sec*
3 - 10 Sec
1 Sec Enable*
Disable
* = Factory Default
1 Available for Zero Tear Pedestal printers only.