Printronix H-SERIES P7000 - Manual (Page 189)

189
Taiwan
Warning:
This is a Class A product. In a domestic environment this product may cause
radio interference in which case the user will be required to take adequate
measures.
Korea
This equipment passed MIC certification. To assure continued compliance
with Electromagnetic Compatibility (EMC) regulatory requirements all
electrical signal interface cables connected to this printer must be of a
minimal quality level, be of a proper length, and be properly installed.
For example, the RS-232 port and parallel port interface cables must meet the
following specifications:
1. The cable design must be double shielded with a copper braid over an
aluminum mylar foil and not just a conductive foil spiral wrapped around a
drain wire.
2. The shield must terminate coaxially (360 degrees) to a metal connector
housing and not be terminated by just a simple wire lead.
3. The cable length, including connectors, must be 3 meters or less.