Proxim AP-4000 - Manual (Page 69)

Advanced Configuration AP-4000 Series User Guide
Management
69
IP Access Table
The Management IP Access table limits in-band management access to the IP addresses or range of IP addresses
specified in the table. This feature applies to all management services (SNMP, HTTP, and CLI) except for CLI
management over the serial port. To configure this table, click Add and set the following parameters:
• IP Address: Enter the IP Address for the management station.
• IP Mask: Enter a mask that will act as a filter to limit access to a range of IP Addresses based on the IP Address you
already entered.
–
The IP mask 255.255.255.255 would authorize the single station defined by the IP Address to configure the
Access Point. The AP would ignore commands from any other IP address. In contrast, the IP mask 255.255.255.0
would allow any device that shares the first three octets of the IP address to configure the AP. For example, if you
enter an IP address of 10.20.30.1 with a 255.255.255.0 subnet mask, any IP address between 10.20.30.1 and
10.20.30.254 will have access to the AP’s management interfaces.
• Comment: Enter an optional comment, such as the station name.
To edit or delete an entry, click Edit. Edit the information, or select Enable, Disable, or Delete from the Status pull-down
menu.
Services
You can configure the following management services:
Secure Management
Secure Management allows the use of encrypted and authenticated communication protocols such as SNMPv3, Secure
Socket Link (SSL), and Secure Shell (SSH) to manage the Access Point.