Proxim AP-4000 - Manual (Page 163)

Command Line Interface (CLI) AP-4000 Series User Guide
CLI Command Types
163
Example 3b. Display parameters based on letter sequence
This example shows entries for parameters that start with the letter “i”. The more letters you enter, the fewer the results
returned. Notice that there is no space between the letters and the question mark.
[Device-Name]> show ipa?
Figure A-6 Result of “show ipa?” CLI command
[Device-Name]> show iparp?
Figure A-7 Result of “show iparp?” CLI command
Example 4. Display Prompts for Successive Parameters
Enter the command, a space, and then ?. Then, when the parameter prompt appears, enter the parameter value. The
parameter is changed and a new CLI line is echoed with the new value (in the first part of the following example, the
value is the IP Address of the TFTP server).
After entering one parameter, you may add another ? to the new CLI line to see the next parameter prompt, and so on
until you have entered all of the required parameters. The following example shows how this is used for the download
Command. The last part of the example shows the completed download Command ready for execution.
[Device-Name]> download ?
[Device-Name]> download 192.168.0.101 ?
[Device-Name]> download 192.168.0.101 apimage ?
[Device-Name]> download 192.168.0.101 apimage img
done, exit, quit
Each of the following commands ends a CLI session:
[Device-Name]> done
[Device-Name]> exit
[Device-Name]> quit
download
Downloads the specified file from a TFTP server to the Access Point. Executing download in combination with the
asterisks character (“*”) will make use of the previously set TFTP parameters. Executing download without parameters
will display command help and usage information.
1. Syntax to download a file:
[Device-Name]>download