Proxim AP-4000 - Manual (Page 211)

Command Line Interface (CLI) AP-4000 Series User Guide
Parameter Tables
211
VLAN/SSID Parameters
Other Parameters
IAPP Parameters
NOTE: These parameters configure the Inter Access Point Protocol (IAPP) for roaming. Leave these settings at their
default value unless a technical representative asks you to change them.
Wireless Multimedia Enhancements (WME)/Quality of Service (QoS) parameters
The Wireless Multimedia Enhancements commands enable and configure Wireless Multimedia Enhancement/Quality of
Service parameters per wireless interface. The following two commands are part of the Wireless Interface Properties
table.
Name Type Value Access CLI Parameter
VLAN Group N/A R vlan
Status Integer enable
disable (default) RW vlanstatus
Management ID VlanId -1 (untagged)
or 1 - 4094 RW vlanmgmtid
Name Type Value Access CLI Parameter
IAPP Group N/A R iapp
IAPP Status Integer enable (default)
disable RW iappstatus
Periodic Announce
Interval (seconds) Integer 80
120 (default)
160
200 RW iappannint
Announce Response
Time Integer 2 seconds R iappannresp
Handover Time-out Integer 410 ms
512 ms (default)
614 ms
717 ms
819 ms RW iapphandtout
Max. Handover
Retransmissions Integer 1 - 4 (default 4) RW iapphandretx
Send Announce Request
on Startup Integer enable (default)
disable RW iappannreqstart