Proxim AP-4000 - Manual (Page 180)

Command Line Interface (CLI) AP-4000 Series User Guide
Other Network Settings
180
[Device-Name]>set serbaudrate <2400, 4800, 9600, 19200, 38400, 57600>
[Device-Name]>set serflowctrl
[Device-Name]>show serial
Figure A-16 Result of “show serial” CLI Command
Configure Syslog
[Device-Name]>set syslogpriority <1–7 (default is 6)>
[Device-Name]>set syslogstatus
[Device-Name]>set sysloghbstatus (default is disable)
[Device-Name]>set sysloghbinterval <1–604800> (default is 900 seconds)
[Device-Name]>set sysloghosttbl ipaddr cmt status
Configure Intra BSS
[Device-Name]>set intrabssoptype
Configure Wireless Distribution System
Create/Enable WDS
[Device-Name]>set wdstbl partnermacaddr status enable
Enable/Disable WDS
[Device-Name]>set wdstbl status
NOTE: is 3.1–3.6 (Wireless A) or 4.1–4.6 (Wireless B). To determine the index, type show wdstbl at the
prompt.
Configure MAC Access Control
Setup MAC (Address) Access Control
[Device-Name]>set wifssidtbl aclstatus enable/disable
[Device-Name]>set macacloptype
[Device-Name]>reboot 0
Add an Entry to the MAC Access Control Table
[Device-Name]>set macacltbl 0 macaddr status enable
[Device-Name]>show macacltbl
Disable or Delete an Entry in the MAC Access Control Table
[Device-Name]>set macacltbl status
[Device-Name]>show macacltbl
NOTE: For larger networks that include multiple Access Points, you may prefer to maintain this list on a centralized
location using the RADIUS parameters (see Set RADIUS Parameters ).