Cli monitoring parameters, Parameter tables, Cli monitoring parameters parameter tables – Proxim AP-4000 User Manual

Page 184

Command Line Interface (CLI)

AP-4000 Series User Guide

CLI Monitoring Parameters

184

Configure a Security Profile with 802.11i Security Mode

[Device-Name]>set secprofiletbl secmode 802.11i rekeyint status enable

Example:
[Device-Name]>set secprofiletbl 7 secmode 802.11i rekeyint 900 status enable

Configure a Security Profile with 802.11i-PSK Security Mode

[Device-Name]>set secprofiletbl secmode 802.11i-psk passphrase status
enable

Example:
[Device-Name]>set secprofiletbl 8 secmode 802.11i-psk passphrase 12345678 status enable

CLI Monitoring Parameters

Using the show command with the following table parameters will display operating statistics for the AP (these are the
same statistics that are described in the

Monitoring

section).

• staticmp: Displays the ICMP statistics.
• statarptbl: Displays the IP ARP Table statistics.
• statbridgetbl: Displays the Learn Table.
• statiapp: Displays the IAPP statistics.
• statradius: Displays the RADIUS Authentication statistics.
• statif: Displays information and statistics about the Ethernet and wireless interfaces.
• stat802.11: Displays additional statistics for the wireless interfaces.
• statethernet: Displays additional statistics for the Ethernet interface.
• statmss: Displays station statistics and Wireless Distribution System links.
• statmesh: Displays statistics about the Mesh network.

Parameter Tables

Objects contain groups that contain both parameters and parameter tables. Use the following Tables to configure the
Access Point. Columns used on the tables include:

• Name - Parameter, Group, or Table Name
• Type - Data type
• Value - Value range, and default value, if any
• Access = access type, R = Read Only (show), RW = Read-Write (can be “set”), W = Write Only
• CLI Parameter - Parameter name as used in the Access Point

Access Point network objects are associated with Groups. The network objects are listed below and associated
parameters are described in the following Parameter Tables:

•

System Parameters

- Access Point system information

–

Inventory Management Information

- Hardware, firmware, and software version information

•

Network Parameters

- IP and Network Settings

–

IP Configuration Parameters

- Configure the Access Point’s IP settings