Proxim AP-4000 - Manual (Page 68)

Advanced Configuration AP-4000 Series User Guide
Management
68
Management
The Management tab contains the following sub-tabs:
• Passwords
• IP Access Table
• Services
• Automatic Configuration (AutoConfig)
• Hardware Configuration Reset (CHRD)
Passwords
You can configure the following passwords:
• SNMP Read Community Password: The password for read access to the AP using SNMP. Enter a password in both
the Password field and the Confirm field. This password must be between 6 and 32 characters. The default
password is “public”.
• SNMP Read/Write Community Password: The password for read and write access to the AP using SNMP. Enter a
password in both the Password field and the Confirm field. This password must be between 6 and 32 characters.
The default password is “public”.
• SNMPv3 Authentication Password: The password used when sending authenticated SNMPv3 messages. Enter a
password in both the Password field and the Confirm field. This password must be between 6 and 32 characters, but
a length of at least 8 characters is recommended. The default password is “public”. Secure Management (Services
tab) must be enabled to configure SNMPv3.
The default SNMPv3 username is administrator, with SHA authentication and DES privacy protocol.
• SNMPv3 Privacy Password: The password used when sending encrypted SNMPv3 data. Enter a password in both
the Password field and the Confirm field. This password must be between 6 and 32 characters, but a length of at
least 8 characters is recommended. The default password is “public”. Secure Management (Services tab) must be
enabled to configure SNMPv3.
• Telnet (CLI) Password: The password for the CLI interface (via serial or Telnet). Enter a password in both the
Password field and the Confirm field. This password must be between 6 and 32 characters. The default password is
“public”.
• HTTP (Web) Password: The password for the Web browser HTTP interface. Enter a password in both the Password
field and the Confirm field. This password must be between 6 and 32 characters. The default password is “public”.
NOTE: For security purposes Proxim recommends changing ALL PASSWORDS from the default “public” immediately, to
restrict access to your network devices to authorized personnel. If you lose or forget your password settings, you
can always perform the
Reset to Factory Default Procedure .