Laser beta lasermike LS8000-3 - Manual (Page 163)

LaserSpeed 8000-3 Instruction Handbook
RS-232/RS-422 Communication
Part No. 93463 / Drawing No. 0921-01561 Page 163 of 221 Revision A (Sep 2007)
*AUTOADDR
UDP Power-On Data Destination IP Address
*AUTOADDR?
Read
Response Format:
*AUTOADDR=
Set
*AUTOADDR=
Where is an IP Address, such as "192.168.10.246". This
command configures the destination IP address for UDP output data. If the gauge is not
configured to output UDP data on start-up, then this setting is not used.
*AUTOPORT
UDP Power-On Data Destination Port
*AUTOPORT?
Read
Response Format:
*AUTOPORT=
Set
*AUTOPORT=
Where is an IP port number, such as 1234. This command configures the destination
Port for UDP output data. If the gauge is not configured to output UDP data on start-up, then
this setting is not used. This port should be set to a value higher than 1024 so that it doesn't
interfere with standard network interfaces.