Laser beta lasermike LS8000-3 - Manual (Page 105)

LaserSpeed 8000-3 Instruction Handbook
LaserTrak Software
Part No. 93463 / Drawing No. 0921-01561 Page 105 of 221 Revision A (Sep 2007)
Search For LaserSpeed- initiates a search for the LaserSpeed gauge to
establish communication
between LaserTrak and the
gauge. If the Serial
checkbox is checked, the
enabled serial ports will be
searched. If the TCP/IP box
is checked, then the local
network will be searched for
gauges. If no gauges are
found, make sure that the
serial port is enabled under
Program Settings.
Program Settings- Shows the active COM Ports. Only
COM Ports that are checked will be searched
during the communication search. Also shows the
default COM Port and operating parameters the
software will use to communicate with the
LaserSpeed gauge. Only the checked serial
ports will be searched for LaserSpeed gauges. If
a new serial port is added to the computer, it
must be selected in this screen before it can be
used with LaserTrak.
LaserSpeed Configuration- opens the operating parameter configuration
screen. There are pages to the Configuration screen.