Laser beta lasermike LS8000-3 - Manual (Page 103)

LaserSpeed 8000-3 Instruction Handbook
LaserTrak Software
Part No. 93463 / Drawing No. 0921-01561 Page 103 of 221 Revision A (Sep 2007)
Enable Vertical Tracking on Start- When Checked, autoscaling on the the
vertical axis will automatically be turned on each time the Start
Readings button is pressed.
Unlock- Unlocks the Factory Setting
or the Terminal Assist. Factory
Settings and Terminal Assist are
both password protected. The
Factory Setting should only be
accessed by authorized
personnel. Terminal Assist can
be used to manually send
commands (like when using HyperTerminal) to help diagnose
communication problems. The password for Terminal Assist is “laser1”.
Note: You must unlock the gauge settings with the "*LOCKED=0"
command before settings can be changed with Terminal Assist.