Kyocera FS-C1020MFP - Manual (Page 458)

Top Page > Maintenance > If the Machine is Not Going to Be Used for a Long Time > Using the Machine Again After It Has Been Inactive
for a Long Period
Using the Machine Again After It Has Been Inactive for a Long Period
Use the following procedure to start using the machine again after it has been inactive for a long period.
●
To avoid damage to the fusing unit's knobs, be sure to turn both knobs back to their original positions, as shown in the
following procedure.
Plug in the power cable.
Pull Front Cover Open Lever, and then open the front cover with both hands carefully.
Lower the blue fusing unit lever.
Using a coin, turn both gray knobs on the fusing unit 90 degrees clockwise (until the
slots are vertically aligned with the marking shown in the illustration below).
Close the front cover with both hands carefully.
Contents Previous Next Settings