Top previous next – Kyocera FS-C1020MFP User Manual

Page 206

display.

Within 30 seconds, place the original back side down and top to the machine rear on the

exposure glass, and then press the [B&W Start] key or [Color Start] key again.

Use the same mode (color or black-and-white) for both sides.

●

Use the following keys to cancel settings:

❍

[ ]: Cancels the changes made to settings and returns the display to the previous screen.

❍

[Clear/Stop]: Cancels the changes made to settings and returns the display to the initial screen.

●

If you do not copy the back side within 30 seconds after copying the front side, the job will be canceled.

●

Regardless of the machine's reduction or enlargement ratio setting, an ID card copy will always be made at 100%.

●

You can change the machine's default [Reduce/Enlarge] setting to always make photocopies in ID card copy mode.

●

Setting this function for the current job temporarily disables the [Duplex Copy] setting automatically. However, after the

temporary job setting is cleared, the duplex copy function will be enabled again automatically.

●

Temporary job settings are cleared in the following cases:

❍

When no input is received for the period of time specified in [Auto Clear] while the initial screen is displayed.

❍

When the [Clear/Stop] key is pressed while the initial screen is displayed.

❍

When the machine's mode is changed.

❍

When the power is turned off.

●

For details about [Reduce/Enlarge], see

●

For details about [Auto Clear], see