Kyocera FS-C1020MFP - Manual (Page 113)

To install the memory unit, align the notch of the unit with the protruding part of the
slot, and then carefully push in the unit at an angle.
Holding the module at an angle, press it down until it clicks into place.
Attach the inner cover, and then fasten the screw.
Attach the memory unit cover.
After installing the memory unit, print the PDL configuration page to confirm the
installation.
If it is installed properly, “384MB” will appear for "Total Memory" under "System Reference" on the PDL
configuration page.
●
After installing the optional memory unit, select the appropriate size for the machine's total memory in the printer driver.
For details, see the printer driver Help.
●
If the memory unit is not properly installed, repeat this procedure. If you cannot install it properly even after reinstallation,
contact your service representative.
●
For details about printing the PDL configuration page, see PDL Settings .
Top Previous Next