Kodak RP 30 - Manual (Page 67)

Operator’s Guide
4. Put the EKTACOLOR Processing Cartridge in the docking station with the sticker
facing up.
5. The preparation of the replenishers starts as soon as the docking station is
closed. During this procedure, the door is locked mechanically and the LED on
the left side of the docking station illuminates steadily.
IMPORTANT: There should always be a cartridge in the docking station to reduce
oxidation. Once the LED is turned off, the cartridge may be removed
and replaced by a full one. Alternatively, the empty cartridge may
remain in the machine until you get a message to insert a new
cartridge.
The replenishers are mixed automatically by the integrated electrically driven mixers.
A preparation is sufficient for about 75 m² (807 ft²) of color negative paper,
equivalent to approximately 1400 8 x 10-in. (20 x 25-cm) prints.
Other Operations to be Performed Prior to
Production Start
1. Set the reference values.
See Paper Processor Settings in Chapter 4.
2. Adjust the equipment to the operators‘ needs (national settings) and to the
production requirements (configurations).
See Settings, Chapter 4.
3. Test the chemistry.
See Testing the Paper Processor in Chapter 5.
4. Calibrate the machine.
See Tests, Chapter 5.
3-8 KODAK PROFESSIONAL RP 30 Laser Printer