Cleaning the densitometer calibration plate, Cleaning the densitometer calibration plate -20 – Kodak RP 30 User Manual
Page 212
Operator’s Guide
Cleaning the Densitometer Calibration Plate
The densitometer is mounted in the paper outlet.
1. Loosen the screw (2) and remove the front cover of the paper outlet (1).
1
2
2. Loosen the knurled screws (1) on the right and left side on the guide plate of the
densitometer unit.
3. Turn the densitometer unit (2) over and clean the calibration plate with a damp
cloth.
4. Clean the guide plates with a damp lint free cloth.
5. Fasten the densitometer unit again with the knurled screws.
6. Fasten the cover of the paper outlet.
CAUTION:
Have a service technician replace any damaged calibration
plates.
8-20
KODAK PROFESSIONAL RP 30 Laser Printer
See also other documents in the category Kodak Printers:
- Printer (67 pages)
- DryView 8900 (144 pages)
- ENDURA CIS-241 (2 pages)
- DS3700 (2 pages)
- NOVAJET 630 (192 pages)
- EasyShare 5500 (122 pages)
- CIS-201 (12 pages)
- ESP 5 (81 pages)
- ESP 5 (24 pages)
- ESP 5 (79 pages)
- ESP 5 (16 pages)
- FC2 (10 pages)
- CS300C (2 pages)
- EasyShare 5100 (86 pages)
- 3000 (36 pages)
- ESP 3.2s (123 pages)
- M700 (2 pages)
- ESP7200 (6 pages)
- CIS-221 (2 pages)
- 6B6640 (84 pages)
- 6000 (76 pages)
- 6000 (2 pages)
- ESP 3.2 (31 pages)
- ESP 1.2 (100 pages)
- ESP 1.2 (2 pages)
- ESP C315 (95 pages)
- ESP C315 (2 pages)
- ESP Office 2150 (7 pages)
- ESP C315 (20 pages)
- HERO 3.1 (34 pages)
- HERO 3.1 (100 pages)
- ESP 7250 (2 pages)
- 8800 (26 pages)
- ESP 9 (143 pages)
- ESP 9 (16 pages)
- E-4028 (8 pages)
- CP-48S (12 pages)
- 5300 (28 pages)
- 5100 (28 pages)
- 5100 (80 pages)
- E-2411 (6 pages)
- ESP 5260 (62 pages)
- PROFESSIONAL ULTRA III Paper E-142 (8 pages)
- ESP Office 6150 (20 pages)