Kodak RP 30 - Manual (Page 127)

Operator’s Guide
Creating a Package Configuration
You can use any combination of order configurations. If a configuration with more
than two paper widths is used for printing, you may be asked to change the paper
magazine.
1. Select Film mask and Film type.
In the RP 30 Laser Printer, both terms correspond to the term Image source.
2. Set the Configuration type to Package.
3. Select sub-configurations or set to OFF.
4. Select Change PpF (number of prints per frame). The default value is 1.
5. Select either Off or On for Index, Backprint, and Autosave
The settings made here are applied. The settings in the single configurations on
which they are based are ignored.
6. Select Configurations.
Only order configurations are offered that match the selected image source (film
mask) and are not packages themselves (the latter cannot be packed any
further) and in which PpF is not zero.
Add configurations to the selection list with , or with .
7. Select Save or Save as.
For the Standard button, see Defining a Configuration as the Standard Configuration
on Page 4-63.
4-60 KODAK PROFESSIONAL RP 30 Laser Printer