Kodak RP 30 - Manual (Page 152)

Operator’s Guide
Changing the Paper Magazine
IMPORTANT:
IMPORTANT:
To let the paper to rewind into the magazine, always wait 30 seconds
after the last print procedure before removing the magazine.
The LED in front of the magazine indicates if the magazine may be removed:
Green: yes
Red: no
1. Remove the paper magazine:
a. Push the locking lever to the side.
b. Pull out the paper magazine.
2. Mount the paper magazine:
a. Open the Printer door.
b. Put the paper magazine on the guide rails and push it in until it locks audibly.
In order to avoid paper transport problems due to an incorrectly cut
paper tip, confirm the prompt in the next step when:
• You have inserted a new paper roll, or
• There is a paper jam
3. If necessary, confirm the prompt for a paper cut.
If the cut is confirmed, the equipment cuts the paper tip (4.75 in.) and transports it
through the paper processor.
IMPORTANT: Whenever a magazine is inserted, the system checks the paper
length by moving the paper to the cutter and back. To prevent the
paper from becoming fogged, make sure the middle printer door
remains closed during this procedure.
6-8 KODAK PROFESSIONAL RP 30 Laser Printer