Kodak RP 30 - Manual (Page 11)

Operator’s Guide
Safety Precautions
Legal Notice
The RP 30 Laser Printer is designed for operation in conformance with all local safety
regulations.
Follow all safety regulations, warnings, and instructions on machine labels. Failure to
observe these regulations may result in personal injury or damage to the equipment
and working area.
The manufacturer and service provider will not assume any responsibility for
accidents and damage resulting from incorrect operation.
General Precautions
• Never modify or rewire electrical circuits.
• Do not circumvent or disable the integrated safety devices.
• Do not modify preset values of safety components.
• Replace fuses only with the same type of fuse (amp value, switch-off
characteristics).
When Operating the Equipment
WARNING: Do not operate the equipment without the covers and panels.
Persons who open or remove covers expose themselves to
dangerous voltages and other risks of injury.
• Do not cover or block the vent openings in the housing. This may lead to
overheating of components.
• Do not allow objects or liquids to enter the equipment through the vent openings.
This may cause fire or electrical shock.
• Do not allow the power cable to be squeezed or crimped. Install the power cable so
that it will not cause someone to step on or trip over it.
• Avoid the excessive generation of dust. This may damage the components in the
machine.
When Disposing of the Equipment
The RP30 contains a small amount of lead in circuit boards and mercury in the
backlight of the LCD monitor. Disposal of these materials may be regulated due to
environmental considerations. For disposal or recycling information, please contact
your local authorities, or in the USA, visit the Electronics Industry Alliance website at
www.eiae.org.
viii KODAK PROFESSIONAL RP 30 Laser Printer