Sierra Wireless RAVEN 1X 20070914 - Manual (Page 39)

Activating your Raven on the Sprint Network
Rev 3.0B Feb.08 34
method is recommended only in situations where the Setup
Wizard is not available and/or when the configuration for the
Raven is unusual.
Caution: It is not possible to activate the Raven using either
AceManager or AceNet.
Using ALEOS
1. Set telnet timeout in to 20 minutes.
AT*TELNETTIMEOUT=20
2. Save the telnet setting.
AT&W
3. Verify ALEOS has established communication to the
internal hardware.
ATI3
4. Enter the activation command appropriate for your type of
account. The SID and NID are optional and only required
if your account type uses them.
· If you have the same number for the MIN and MDN or
MSID:
AT*PROVISION=MSL,MDN[,SID,NID]
· If you have the different numbers for the MIN and MDN
or MSID:
AT*PROVISION2=MSL,MDN,MIN/MSID[,SID,NID]
Using Direct Commands to the Internal
Hardware
Use only if the ALEOS method is unsuccessful.
Activating the Modem
1. Set telnet timeout in to 20 minutes.
AT*TELNETTIMEOUT=20
2. Save the telnet setting.
AT&W
3. Verify ALEOS has established communication to the
internal hardware.
ATI3
4. Put modem into passthru mode to by‐pass ALEOS. This
will allow direct communication with the wireless module
for programming. Entering passthru will take 10‐15
seconds and will return an ‘OK’ when it is complete.
AT\APASSTHRU