Sierra Wireless RAVEN 1X 20070914 - Manual (Page 145)

Circuit Switch Communications
Rev 3.0B Feb.08 140
Commands Specific to the Raven 1x C3210 and C3216
The command string cannot contain any spaces, commas, the
plus (+) symbol, or a semi‐colon (;). If an AT command needed
for the string contains a plus or comma (for example,
+IFC=0,0), you will need to designate a break character since
you cannot use the standard break of ; for the plus to be read
and a replacement for the comma. The break and comma
designations need to be at the end of the *PTINIT command
and separated with commas. During the INIT sequence, the
modem looks at the entire command before executing the AT
command string. If there are replacement values, it will
perform the appropriate replacement before executing the AT
command.
Commands Specific to the Raven 1x C3211
No special characters are needed for BREAK and comma
though some commands will require a ‘line break’, ;AT.
Table 2-1: Example for the Raven C3210 and C3216
Command Components
AT*PTINIT= AT&C1S0=1$QCVAD=4%+IFC=0^0,%,^ AT*PTINIT=
Include this portion only if you will not be entering
the command using a AceManager. The
remainder of the example is the command string.
AT
All AT commands must start with “AT”.
&C1S0=1$QCVAD=4%+IFC=0^0
The string is a combination of AT Commands
limited to a maximum of 40 characters.
,% [,break]
Optional “BREAK” character to allow the use of a
command with a “+”. In the example, a “%” is used.
,^ [,comma]
Optional comma replacement character to allow
the use of a command requiring a comma. In the
example, a ^ is used.