Sierra Wireless RAVEN 1X 20070914 - Manual (Page 123)

Configuration Commands
Rev 3.0B Feb.08 118
• n=2 : Second IP Manager server.
• key=128‐bit key in hexadecimal [32 hex characters]
*IPMGRUPDATEn=m
Sets the number of minutes to periodically send an IP update
notification to the corresponding server. This will occur even if
the IP address of the Raven doesnʹt change. *IPMGRUPDATE1
is used to set the refresh rate to *IPMANAGER1, while
*IPMGRUPDATE2 is used with *IPMANAGER2. If the value is
set to 0, then periodic updates will not be issued (i.e. IP change
notifications will only be sent when the IP actually changes).
• n=1 : First IP Manager server.
• n=2 : Second IP Manager server.
• m=0, 5‐255 : Number of minutes to send an update.
*MODEMNAME=name
Name of the Raven (up to 20 characters long) to use when
performing IP address change notifications to IP Manager. The
value in *DOMAIN provides the domain zone to add to this
name.
• name=modem name (for example, mymodem)
Example: if *MODEMNAME=mymodem and
*DOMAIN=eairlink.com, then the modemʹs fully qualified
domain name is mymodem.eairlink.com.
Automatically Generated Names:
#I3 ‐ The ESN/IMEI will be used as the name.
#CCID ‐ The CCID will be used as the name.
#NETPHONE ‐ The phone number will be used as the name.
Tip: Each modem using IP Manager needs a unique name. Two
modems cannot be called “mymodem”. One could be “mymodem1”
with the other as “mymodem”.
PPP/Ethernet
This group includes commands specific to PPP (serial) or
Ethernet connections between the Raven and a connected
device.