Sierra Wireless RAVEN 1X 20070914 - Manual (Page 114)

Raven 1x
109 20070914
Tip: Can also be set using &L=[speed],[databits] [parity][stop bits]
S50=n
Data forwarding idle time‐out. If set to 0, a forwarding time‐
out of 10ms is used. Used in UDP or TCP PAD mode.
• n=tenths of a second
S51=n
PAD data forwarding character. ASCII code of character that
will cause data to be forwarded. Used in UDP or TCP PAD
mode.
• n=0 : No forwarding character.
S211=n
For applications or situations where hardware control of the
DTR signal is not possible, the modem can be configured to
ignore DTR. When Ignore DTR is enabled, the modem
operates as if the DTR signal is always asserted.
• n=0 : Use hardware DTR. (default).
• n=1 : Ignore DTR.
• n=3 : Ignore DTR and assert DSR. This value is deprecated,
and it is recommended to use &S to control the DSR
instead. When this value is set to 3, &S will automatically
be set to 0. See also: &D and &S.
Vn
Command Response Mode.
• n=0 : Terse (numeric) command responses
• n=1 : Verbose command responses (Default).
Xn
Extended Call Progress Result mode.
• n=0 : Turn off extended result codes (Default).
• n=1 : Turn on result codes. This adds the text 19200 to the
CONNECT response.
&Cn
Set DCD mode.
• n=0 : Always assert DCD.
• n=1 : Assert DCD when in a data mode (UDP, TCP, PPP, or
SLIP) (Default).
• n=2 : Assert DCD when the modem has network coverage.