Sierra Wireless RAVEN 1X 20070914 - Manual (Page 125)

Configuration Commands
Rev 3.0B Feb.08 120
*HOSTPEERIP=d.d.d.d
Set or query the IP address that can be used to directly contact
the Raven once a cellular connection is established. If this
value is not specified, 192.168.13.31 will be used.
• d.d.d.d=local or peer IP address of the modem.
Note: This is not normally used nor needed by user applications.
*HOSTPRIVIP=d.d.d.d
Set or query the private IP address that is to be negotiated by
the 1x connection if *HOSTPRIVMODE =1.
• d.d.d.d=IP Address
*HOSTPRIVMODE=n
Set or query whether a private or public (network) IP is to be
used when the Host initiates a 1x connection to the modem.
• n=0 : Public (network) IP Mode: When the Host initiates a
PPP connection, the host will be given the network IP
address that was obtained from the cellular carrier while
registering on the network. If the network issues a new IP
address, the cellular connection will be closed (since the IP
address has changed) and has to be re‐initiated. (default).
• n=1 : Private IP Mode: When the Host initiates a 1x
connection, the host will be given the IP address specified
in *HOSTPRIVIP. The modem will then perform 1 to 1
NAT‐like address translation, which shields the Host from
network IP changes.
*HOSTPW=string
Host Password for PAP or CHAP.
• string=password
*HOSTUID=string
Host User ID for PAP or CHAP.
• string=user id (up to 64 bytes)
PassThru
PassThru Mode is used to communicate directly to the Raven
internal hardware.