Savin C3210 - Manual (Page 31)

Copying from the Bypass Tray
21
2
BBBB
Insert the paper with the side you
want to copy facing down until
you hear the beep, and align the
paper guide to the paper size.
1. Extender
Note
❒ If the guides are not flush with
the copy paper, images might
be skewed or paper misfeed
might occur.
❒ Do not stack paper over the lim-
it m a rk , o t h e rw is e i m a g e s
might be skewed or paper mis-
feed might occur.
❒ When you load the OHP trans-
parencies, check the front and
back of the sheets, and place
them correctly, or a misfeed
might occur. Set the paper di-
rection to
K and select A4K,
8 1 /
2
"
× 11"K as paper size in
step
C.
❒ Swing out the extender to sup-
port paper sizes larger than
A4
L, 8 1 /
2
"
× 11"L.
❒ Fan paper to get air between the
sheets and avoid a multi-sheet
feed.
❒ When copying onto envelopes:
⇒ p.22 “When copying onto en-
velopes”.
CCCC
Select the type and size of the pa-
per.
When copying onto standard size
paper
A Press the {{{{#}}}} key.
B Press [Select Size].
C Select the paper size.
D Press [OK].
When copying onto custom size
paper
Note
❒ Paper will be automatically de-
livered to the internal tray.
A Press the {{{{#}}}} key.
B Press [Custom Size].
C Press [Vertical inch], enter the
vertical size of the paper with
the number keys, and then
press [#].
D Enter the horizontal size of the
paper with the number keys,
and then press [#].
Note
❒ If [Horiz inch] is not highlight-
ed, press [Horiz inch].
❒ When vertical size more than
297.1mm (11.70"), horizontal
size m ore than 432.1mm
(17.01") is entered, the image
will be copied in the center of
the paper.
UranosC1-ENcopyA_F1_FM.book Page 21 Friday, July 26, 2002 5:01 PM