beautypg.com

Ipp -16 – Savin AC205 User Manual

Page 324

background image

Page 3-16

Administrator Guide

Ne

twor

k

Ins

ta

lla

tio

n

Us

in

g In

ter

n

e

t Se

rv

ic

e

s

IPP

Use these instructions to setup IPP using Web Image Monitor Type 103.

NOTE: The HTTP settings for the device will have been setup when completing the
Enabling Web Image Monitor Type 103 section.

To complete the installation of the device, perform these steps:

¾

Enable Web Image Monitor Type 103 (see “Enabling Internet Services” on page 3-5).

¾

At the Web Image Monitor Type 103 Home Page for the Type 103, select the [Network
Settings]
tab.

¾

In the Network Settings, select [Raw TCP/IP, LPR, IPP].

¾

Select the checkbox to enable IPP.

Check the IPP Configuration details are correct. If any of the details are incorrect then
enter the required configuration details in the appropriate boxes.

In the IPP tab, configure the parameters.

Printer URI: Enter the URL of the printer using the following format:

ipp://the IP address of the printer or http://the IP address of the printer:631

(Ex:ipp://168.10.17.82 or http://168.10.17.82:631) 631 is the IPP port number.

Printer Name: Enter the network printer’s name to use with the IPP printing.

Operator message: Enter the printer information for printer users.

Printer Location: Enter the name of the location where the printer is physically

located.

Printer Information: Enter additional information about the printer.

Multiple Operation Timeout: Enter the time the printer ends a print job. When

there is no incoming data after the specified number of seconds, the printer ends
the reception.

Time to Keep Jobs in History: Set the length of time the IPP printer keeps the job

information.

¾

Click the [Apply] button to implement any changes.

NOTE: Click the [Undo] button to cancel any changes made and return to the
previous values.

1

2

3

4

5