Savin AC205 - Manual (Page 311)

Administrator Guide Page 3-3
Ne
twor
k
Ins
tal
la
tio
n
Us
in
g In
ter
net
Se
rv
ic
es Using Web Image Monitor Type 103
Introduction
Web Image Monitor Type 103 uses the embedded HTTP Server on the Type 103 to allow
communication with the Type 103 if you have a Web Browser with access to the Internet or
Intranet. By entering the IP Address of the Type 103 as the URL (Universal Resource Locator)
in the Browser, direct access to the Type 103 is available.
NOTE: Microsoft Internet Explorer version 4.x or later should be used. Other
browsers may work, but could produce unexpected results.
Many of the selections and settings needed to install Type 103 on a network can be made
using Internet Services, eliminating steps that would otherwise need to be performed at the
Type 103 Control Panel.
Many of the features available within Internet Services will require an admin user name and
password. A user will only be prompted for an admin name and password once in a single
browser session.
Before the Internet Services feature can be used for installing Type 103 on a network it must
be enabled. There are two stages required to enable Internet Services:
¾ Network Communication Setup
This requires the Type 103 to be setup for Internet Services.
¾ Enable Internet Services
¾ Make settings to the appropriate network
NOTE: When making more than one configuration change please complete all the
changes in one go and then carry out a reboot.