Savin AC205 - Manual (Page 322)

Page 3-14 Administrator Guide
Ne
twor
k
Ins
ta
lla
tio
n
Us
in
g In
ter
n
e
t Se
rv
ic
e
s Raw TCP/IP Printing
Use these instructions to enable or disable Raw Printing using Web Image Monitor Type 103.
Installation Procedure
There are two stages required to install the device on an Raw TCP/IP printing network using
Web Image Monitor Type 103:
¾ Configure the Type 103
This procedure explains how to use Web Image Monitor Type 103 to configure
the device.
¾ Test Print
A print job should be submitted to ensure the device has been installed and
configured correctly.
Configure the Type 103
To complete the installation of the Type 103, perform these steps:
¾ Enable Web Image Monitor Type 103 (see “Enabling Internet Services” on page 3-5).
¾ At the Web Image Monitor Type 103 Home Page for the Type 103, select the [Network
Settings] tab.
¾ In the Network Settings, select [Raw TCP/IP, LPR, IPP].
Enter the [Port Number] and then enter the required port number.
NOTE: While you can change the port number at which the Type 103 will accept
RAW print jobs, it is recommended that you use the default port, 9100. this is the
industry standard
¾ Click the [Apply] button to implement any changes.
NOTE: Click the [Undo] button to cancel any changes made and return to the
previous values.
1
2
3
4