Sony Ericsson P800 - Manual (Page 57)

Phone 57
This is the Internet version of the user’s guide. © Print only for private use.
• Program digit
sequences into a
Contact card for the
service. Each digit
sequence to be sent
as tones must begin
with a
p .
Once your call to
the service has been
established and you
want to send one of
your pre-
programmed digit
sequences, choose
Show contact on the
Phone menu to get
to the Contact card
with the tone
sequences.
Note It is not advisable to program any personal codes into
your P800, in case your phone is stolen or lost.
Preferences
In this menu you can change the settings for the telephony
options. (Settings on your P800 that are system-wide and affect
more than one application are made from the Control panel, see
“Control panel” on page 147).
To set the telephony preferences
1. Select Phone > Edit > Preferences.
2. Select the item to set up.
Sounds and alerts
Use these settings to control how your P800 should alert you of
an incoming call. You can choose to use any sound recording or
audio file. For more information see “Ring signals” on
page 145.
You may personalize the ring melodies further for individual
contacts, see “To change the details of a contact” on page 104.
• Ring volume – Set the preferred sound level for handheld,
handsfree and car use.
• Increasing ring – Select the checkbox to use increasing ring
signals. This disables the other volume settings.
• Ring (voice) – Select a ring signal for incoming voice calls.
Tap the trumpet to listen to the signal. Tap again to stop
playback.
Contacts Edit Unfiled
Bank
+4613244500 p1#1234567890
p10#0#34#56789 (w)
p30#1234#56 (w)
p10#1#567890123 (w)
p20#123456789 (w)