IBM Oce TDS400 - Manual (Page 64)

64 Océ TDS400 User Manual
Stop a copy job
Press the ‘cancel’ key to interrupt the original transport.
▼ Stop a job
1 Press the ‘cancel’ key.
The original transport is stopped.
2 The message ‘Remove original’, ‘Press cancel’ appears on the scanner display.
3 Open the scanner cover and remove the original.
4 Close the cover.
5 Press the ‘cancel’ key. The message disappears on the scanner display.
Set synchro or standard cut
In synchro cut mode, the copy is cut at the length of the original. The length
depends on the zoom factor and the leading or trailing strip setting. The default
is Synchro cut mode.
In standard cut mode, the copy is cut at a standard format length (portrait). You
select the length of the standard format with the ‘browse’ keys.
Example: select 36 inches, means select a format of 36 inches width and a
corresponding 48 inches length. Independent of the roll width, the material is
cut at a length of 48 inches.
When you select standard cut, the system always cuts at the selected length. If
the original length is shorter or longer than the selected length, the cut is made
at the selected length.
▼ Select synchrone cut
1 Press the Extra key.
2 Select ‘Paper copy’ with the or key.
3 Press key, to enter the ‘Paper copy’ menu.
4 Select ‘cut length’ with the or key.
5 Press key, to enter the ‘cut length’ menu.
6 Select ‘on’ or ‘off’ with the or key.
7 Press the ‘confirm’ key.