IBM Oce TDS400 - Manual (Page 41)

Using the Océ TDS400 to Print 41
Paper series
You must enter the paper series that you use in the printer. Choose between:
■
DIN
■
DIN CARTO
■ Only 8.5 inch
■
Mix 8.5/9 inch
▼ To set a paper series
1 Press the On-line key to put the printer off-line.
2 Select the ‘Configuration’ item with the or key.
3 Press Next/select to enter the ‘Configuration’ menu.
4 Select ‘Paper series’ with the or key.
5 Press Next/select to enter the ‘Paper series’ menu.
6 Select the required paper series with the or key.
7 Press Next/select to confirm.
8 Press On-line to put the printer on-line again.
Clear set memory
The set memory indicates the available memory. If an error occurs, for example
the set memory reaches its limits, you must clear the set memory.
▼ Clear set memory
1 Press the On-line key to put the printer off-line.
2 Select the ‘System ’ item with the or key.
3 Press Next/select to enter the ‘System’ menu.
4 Enter the password to get access.
5 Select the ‘Clear setmem’ item with the or key.
6 Press Next/select to enter the ‘Clear setmem’ menu.
7 Select ‘Yes’ or ‘No’ with the or key.
8 Press Next/select to confirm the setting.
9 Press On-line to put the printer on-line again.
10 Turn ‘off’ and ‘on’ the controller.
Diagnostic mode
The Diagnostic mode is only meant for the Océ service technician.