IBM Oce TDS400 - Manual (Page 188)

188 Océ TDS400 User Manual
[109] Opening the plate
3 Remove any jammed printing material.
4 Squeeze the two knobs again and put the plate in its original position.
5 Release the green lever in the lower section of the belt unit (by slightly lifting
it and pulling it forward) to open the lower plate (see Figure 110).
[110] Opening the lower plate
6 Remove any jammed printing material.
7 Pull up the green lever again (until it locks into position) to close the plate.
8 Close the belt unit door.
9 Put the belt in its operating position by pushing it down gently.