IBM Oce TDS400 - Manual (Page 172)

172 Océ TDS400 User Manual
3 Close the waste box by first pushing it forwards and next pushing it to the right
hand side.
[88] Closing the waste box
Clean the reinforcement knives
Because the knives of the reinforcement unit get sticky from the glue on the
reinforcement tape, they have to be cleaned regularly. You are recommended
to clean the knives each time you have inserted a new tape roll (see ‘Insert a
new tape roll’ on page 164) or when an error in the reinforcement unit has
occurred.
If you want to clean the reinforcement knives, you have to place them in such
a position that all the parts that need to be cleaned are accessible.
Attention: Only use the original Cleaner K and Fixing Unit Cleaning Oil
(silicon oil) from Océ, to avoid damage to the reinforcement unit.
▼ How to clean the reinforcement knives
1 Press the On-line key on the printer operator panel.
2 Select ‘Folding’ with the or key.
3 Press the key to enter the ‘Folding’ menu.
4 Select ‘Clean RU knife’ with the or key.
5 Press the key to place the reinforcement unit knives in the correct position.
6 Open the side door of the reinforcement unit.
7 Clean the upper and lower knife using Cleaner K (see Figure 89).